HomeFAQSearchRegisterUsergroupsBlogLog inGolden Tom 2014 Thread!

Share | 
 

 Thickness of materials

View previous topic View next topic Go down 
AuthorMessage
Eliazar
Etheral
Etheral


Posts : 1973
Trading Reputation : 1
Join date : 2007-08-27
Age : 28
Location : Frankfurt, Germany

Personal Info
Primary Warband played: Pirates (Unofficial) Pirates (Unofficial)
Achievements earned: none

PostSubject: Thickness of materials   Sat 24 Jan 2009 - 6:22

I just found a German online-shop selling a lot of hobby material and just wanted t ask about the thickness of certain materials... So, what thickness should a sheet of plasticard have, what should be the diameter of plastic rods and tubes and is 5mm too thick for a sheet of foamcore board?

Thanks in advance!
Back to top Go down
View user profile
jackanory
Warlord
Warlord


Posts : 280
Trading Reputation : 0
Join date : 2008-09-22
Age : 30
Location : Bristol, UK

Personal Info
Primary Warband played: Skaven Skaven
Achievements earned:

PostSubject: Re: Thickness of materials   Sat 24 Jan 2009 - 6:49

doesn't that depend what they're being used for? :/
Back to top Go down
View user profile
Eliazar
Etheral
Etheral


Posts : 1973
Trading Reputation : 1
Join date : 2007-08-27
Age : 28
Location : Frankfurt, Germany

Personal Info
Primary Warband played: Pirates (Unofficial) Pirates (Unofficial)
Achievements earned: none

PostSubject: Re: Thickness of materials   Sat 24 Jan 2009 - 7:11

Hm, yes, sort of... So, foamcore for buildings, plasticard for armour, swords and vehicles and plastic rods for bionic limbs and weapon shafts.
Back to top Go down
View user profile
JAFisher44
General
General


Posts : 183
Trading Reputation : 0
Join date : 2009-01-15
Age : 39
Location : Elma, WA, USA

Personal Info
Primary Warband played: Dwarfs Dwarfs
Achievements earned: none

PostSubject: Re: Thickness of materials   Tue 27 Jan 2009 - 14:28

I use 1/4 inch foamcore for buildings, so 5mm should be ok. If anything, it may be a little too thin.
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: Thickness of materials   Today at 14:47

Back to top Go down
 
Thickness of materials
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Piston materials
» chinese elm forest- from common "S" shape materials
» Wasp Head Gasket Thickness
» Foden boilers
» Resin Casting and Duplication

Permissions in this forum:You cannot reply to topics in this forum
Tom's Boring Mordheim Forum :: General Discussion :: Painting and Modelling-
Jump to: